Shannon's Journal Discussion Thread, Vol. 8

[Shannon]

Hi shannon, looking at giving x4A-1511 a try, since its more powerful then previous version i thought might give it a try, also instructions for one loop on phone can make sure volume is accurate. Only question is since hearing aids are bluetooth to the phone should i turn this part off and let it go through speakers or maybe try with it going directly through my hearing aids into my ears.

I know i havent had much luck in the past but its as close to 6g as possible so maybe any resistance or hearing issues may not be an issue with this amount of power from the subliminal and thought to give it a try.

If you have suggestions which you feel might be best would be great.

thanks
josh.

I unfortunately don't know enough to really guide you on this.  I don't have any hearing impaired people in my life right now to test for me, and I don't know much about hearing aids.  I don't know what kinds of codecs your bluetooth connection uses, or if it therefore strips out the subliminal audio or not.  I don't know how your hearing aid would respond to either form of subliminalized audio. 

Power alone isn't the solution, and that's been apparent for several sub-generations now.  That's why I am going for impact instead of power.  I don't see resistance being something that is very likely to be a major problem at this point, which leaves the hearing issue. 

Most of the resistance tactics showing up in response to 5.11G are:
1. Cause the user to forget to use it.
2. Cause the user to rationalize some other subliminal that will either replace the one that is being resisted, or disrupt it because they were used together.
3. Cause the user to rationalize not using a subliminal at all for some reason.
4. Make the user as uncomfortable as possible in response to using the subliminal. (Anxiety, stomach cramps, etc.)

Even these seem to be rare.

I'm guessing you tried X4A-1000 previously?  Did you notice anything?